Enabling arbitrary wavelength frequency combs on chip

A necessary condition for generation of bright soliton Kerr frequency combs in microresonators is to achieve anomalous group velocity dispersion (GVD) for the resonator modes. This condition is hard to implement in the visible as well as ultraviolet since the majority of optical materials are characterized with large normal GVD in these wavelength regions. We overcome this challenge by borrowing ideas from strongly dispersive coupled systems in solid state physics and optics. We show that photonic compound ring resonators can possess large anomalous GVD at any desirable wavelength, even if each individual resonator is characterized with normal GVD. Based on this concept, we design a mode‐locked frequency comb with thin‐film silicon nitride compound ring resonators in the vicinity of the rubidium D₁ line (794.6 nm) and propose to use this optical comb as a flywheel for chip‐scale optical clocks.

     

Stimulated Raman scattering in natural crystals of fluorapatite,Ca5(PO4)3F

Hexagonal Ca₅(PO₄)₃F, known as natural crystal fluorapatite and oldest host‐crystal for Ln³⁺‐lasant ions, is presented as a Raman‐active material. High‐order Raman‐induced χ⁽³⁾‐nonlinear processes are discovered in natural crystals of fluorapatite under picosecond pumping at 1.064 μm and 0.532 μm wavelength. A multitude of Stokes and anti‐Stokes components is generated in the ultraviolet, visible and near‐infrared spectral region by stimulated Raman scattering (SRS) and Raman four‐wave mixing (FWHM), resulting in a frequency comb with a width of 520 THz. The spectral lines are identified and attributed to the ν₁(A_g) vibration mode of the tetrahedral [PO₄] units which is related to a Raman shift of ω_SRS ≈ 965 cm⁻¹. The first Stokes steady‐state Raman gain coefficient in the near‐infrared spectral range is estimated to be >0.38 cm·GW⁻¹. Finally, a short review of SRS‐promoting vibration modes and observed χ⁽³⁾‐ nonlinear interactions in all known SRS‐active natural crystals (minerals) is given.

     

Frequency ratios of Sr,Yb, and Hg based optical lattice clocks and their applications

This article describes the recent progress of optical lattice clocks with neutral strontium (⁸⁷Sr), ytterbium (¹⁷¹Yb) and mercury (¹⁹⁹Hg) atoms. In particular, we present frequency comparison between the clocks locally via an optical frequency comb and between two Sr clocks at remote sites using a phase-stabilized fibre link. We first review cryogenic Sr optical lattice clocks that reduce the room-temperature blackbody radiation shift by two orders of magnitude and serve as a reference in the following clock comparisons. Similar physical properties of Sr and Yb atoms, such as transition wavelengths and vapour pressure, have allowed our development of a compatible clock for both species. A cryogenic Yb clock is evaluated by referencing a Sr clock. We also report on an Hg clock, which shows one order of magnitude less sensitivity to blackbody radiation, while its large nuclear charge makes the clock sensitive to the variation of fine-structure constant. Connecting all three types of clocks by an optical frequency comb, the ratios of the clock frequencies are determined with uncertainties smaller than possible through absolute frequency measurements. Finally, we describe a synchronous frequency comparison between two Sr-based remote clocks over a distance of 15 km between RIKEN and the University of Tokyo, as a step towards relativistic geodesy.     

Thickness dependent magnetic and ferroelectric properties of LaNiO3 buffered BiFeO3 thin films

BiFeO₃ (BFO) thin films with thickness increasing from 40 to 480 nm were successfully grown on LaNiO₃ (LNO) buffered Pt/Ti/SiO₂/Si(100) substrate and the effects of thickness evolution on magnetic and ferroelectric properties are investigated. The LNO buffer layer promotes the growth and crystallization of BFO thin films. Highly (100) orientation is induced for all BFO films regardless of the film thickness together with the dense microstructure. All BFO films exhibited weak ferromagnetic response at room temperature and saturation magnetization is found to decrease with increase in film thickness. Well saturated ferroelectric hysteresis loops were obtained for thicker films; however, the leakage current dominated the ferroelectric properties in thinner films. The leakage current density decreased by three orders of magnitude for 335 nm film compared to 40 nm film, giving rise to enhanced ferroelectric properties for thicker films. The mechanisms for the evolution of ferromagnetic and ferroelectric characteristics are discussed.     

Frequency-locking and threshold current-lowering effects of a quantum cascade laser and an application in gas detection field

In this paper,the frequency-locking and threshold current-lowering effects of a quantum cascade laser are studied and achieved.Combined with cavity-enhanced absorption spectroscopy,the noninvasive detection of H_2 with a prepared concentration of 500 ppm in multiple dissolved gases is performed and evaluated.The high frequency selectivity of 0.0051 cm~(-1) at an acquisition time of 1 s allows the sensitive detection of the(1-0) S(l) band of H_2 with a high accuracy of(96.53±0.29)%and shows that the detection limit to an absorption line of 4712.9046 cm~(-1) is approximately(17.26±0.63) ppm at an atmospheric pressure and a temperature of 20 ℃.     

QoS enhancement in OFDM based systems under transceiver impairments

Broadband wireless systems generally use orthogonal frequency division multiplexing (OFDM) with link adaptation (LA) to achieve high throughput while meeting bit error rate (BER) constraint. OFDM systems are known to be affected by non-linearity of high power amplifier (HPA) at transmitter, carrier frequency offset (CFO), symbol timing offset (STO) and channel estimation error at the receiver. The delay in feedback of channel state information (CSI) further affects the performance of LA procedures. The focus of this work is on performance analysis in presence of simultaneous affect of all these impairments on LA based OFDM systems. The results are found to be useful for threshold readjustment which is essential for successful implementation of LA scheme to counter the effects of change in operating conditions from ideal to as listed above.     

磷酸钾缓冲溶液与模型细胞膜相互作用的和频光谱

利用和频光谱技术详细研究了磷酸钾缓冲溶液与带负电荷的生物仿生膜(d₅₄-DMPG磷脂双层膜)相互作用的实时过程．通过监控CD₂、CD₃、磷脂分子头部的磷酸根以及羰基官能团的光谱信号随加入磷酸钾缓冲溶液的实时变化,获得了磷脂双层膜分子结构的动力学变化．结果表明K⁺能够结合到细胞膜上,并且很快地引起了CD₂、CD₃、磷脂头部磷酸根以及羰基官能团信号的变化．根据各官能团的和频信号响应,磷酸钾缓冲溶液很可能是通过在双层膜中形成环形气孔来与磷脂双层膜发生作用．该结果可以很好地解释磷酸钾缓冲溶液环境下的离子协助蛋白质的跨膜过程．     

Toward automatic evaluation of defect detectability in infrared images of composites and honeycomb structures

Non-destructive testing (NDT) refers to inspection methods employed to assess a material specimen without impairing its future usefulness. An important type of these methods is infrared (IR) for NDT (IRNDT), which employs the heat emitted by bodies/objects to rapidly and noninvasively inspect wide surfaces and to find specific defects such as delaminations, cracks, voids, and discontinuities in materials. Current advancements in sensor technology for IRNDT generate great amounts of image sequences. These data require further processing to determine the integrity of objects. Processing techniques for IRNDT data implicitly looks for defect visibility enhancement. Commonly, IRNDT community employs signal to noise ratio (SNR) to measure defect visibility. Nonetheless, current applications of SNR are local, thereby overseeing spatial information, and depend on a-priori knowledge of defect’s location. In this paper, we present a general framework to assess defect detectability based on SNR maps derived from processed IR images. The joint use of image segmentation procedures along with algorithms for filling regions of interest (ROI) estimates a reference background to compute SNR maps. Our main contributions are: (i) a method to compute SNR maps that takes into account spatial variation and are independent of a-priori knowledge of defect location in the sample, (ii) spatial background analysis in processed images, and (iii) semi-automatic calculation of segmentation algorithm parameters. We test our approach in carbon fiber and honeycomb samples with complex geometries and defects with different sizes and depths.     

Pretreatment of garlic powder using sweep frequency ultrasound and single frequency countercurrent ultrasound: Optimization and comparison for ACE inhibitory activities

The sweep frequency ultrasound (SFU) and single frequency countercurrent ultrasound (SFCU) pretreatments were modeled and compared based on production of angiotensin I-converting enzyme (ACE) inhibitory peptides from garlic hydrolysates. Two mathematical models were developed to show the effect of each variable and their combinatorial interactions on ACE inhibitory activity. The optimum levels of the parameters in SFU were determined using uniform design, which revealed these as follows: total ultrasonic time 1.5 h, on-time of pulse 18 s and off-time of pulse 3 s. Under optimized conditions, the experimental values of SFU and SFCU were 65.88% and 67.78%, which agreed closely with the predicted values of 63.44% and 67.33%. The SFU and SFCU pretreatments both resulted in higher ACE inhibitory activity compared with untreated garlic (p < 0.05). However, there were no significant differences in the ACE inhibitory activities and IC₅₀ values obtained from SFCU and SFU pretreatments under optimum conditions (p > 0.05).